Manual Jack Handle - Goose-neck
Replacement manual jack handle for single speed and two speed, square leg jack on our goose-neck trailers.
<iframe src="https://store.shadowtrailerworld.com/shop.html" width="100%" height="2000"></iframe>
Replacement manual jack handle for single speed and two speed, square leg jack on our goose-neck trailers.
A-Frame trailer jack mounts to the front A-frame of a bumper-pull trailer. Wheel or foot plate sell separately.
This door hinge has the aluminum cap pressed on at one end to secure the hinge pin (sold separately). Two of these with a hinge pin will make one complete hinge to attach on the door and the frame.
This is only the molded Saddle Boss piece. Has no mounting arm or hardware. Please see other items for a complete assembly.
12 Volt Oscillating Fan, with on/off switch. Plastic housing to avoid rusting that usually occurs with metal fans in a horse trailer or RV because of the high humidity levels.
Shadow built folding aluminum step. Available in 2 sizes: 32 inches and 36 inches. Measure the width of the door that you want to install it under. 32 in. $201.76 36 in. $209.82
This vent mounts to the aluminum roof in the livestock / cargo area. If you are replacing a vent, you will need to re-seal around the vent to prevent leaks. If you are adding this vent to a roof without vents, you will need to add framing for mounting, as well as seal the perimeter to prevent water leaks.
This Foot Plate fits on the bottom of the A-frame jack on a Shadow bumper-pull trailer. It can be used in place of the caster wheel.
Shore Power Receptacle is available in white and black as well as 30 amp and 50 amp service. 30 amp $27.56 50 amp $40.69
Small Black folding step. Used inside a goose-neck trailer to step up into the front nose area. Also used on the rear of an 8 - 8.5 feet wide with a rear platform. Can be used for a wide variety of uses and areas.
Please specify what key number you need. Example: AE004 This number is on the existing lock and on you key. If you do not have either, give us the last 8 of the VIN.
Used inside as a cargo light, rear load light, or a porch light. Have on/off switch.
Bolt on part to hold up your Shadow load ramp.
This aluminum D Ring is used in a few different places. It is a replacement Outside Horse Tie and also used to hold the butt and chest bars in place inside the trailer. If you need the diamond blacker purchase this part and part # ST-DB.
Please enter your contact information and one of our representatives will get back to you with more information.